| Carbon
Monoxide (known by the chemical symbol CO) is a colorless and practically
odorless gas. It is poisonous to people and animals, because it displaced
oxygen in the blood. It is produced by the incomplete burning of solid, liquid,
and gaseous fuels. Appliances fueled with natural gas, liquefied petroleum (LP
gas), oil, kerosene, coal or wood may produce CO. Burning charcoal produces
CO. Running cars produce CO.
According to the Consumer Product Safety
Commission, every eyar over 200 people in the United States die from CO produced
by fuel-burning appliances (furnaces, ranges, water heaters, room heaters).
Others die from CO produced by cars left running in attached garages. Several
thousand people go to hospital emergency rooms each year for treatment for CO
poisoning.
What are the symptoms of CO
poisoning?
CO can have different affects on people based on
its concentration in the air that people breathe. Because you can't smell,
taste, or see it, you cannot tell that CO gas is present. The health effects of
CO depend on the level of CO and length of exposure, as well as the individual's
health condition.
The initial symptoms of CO poisoning are similar to
the flu (but without the fever). They include:
- Headache
- Fatigue
- Shortness of breath
- Nausea
- Dizziness
Many people with CO poisoning mistake their
symptoms for the flu or are misdiagnosed which sometimes results in tragic
deaths.
Because CO replaces oxygen in the blood, it can
make people feel sleepy. Or, if they are asleep, it can prevent people from
waking up.
At higher concentrations, people can experience
impaired vision and coordination, headaches, dizziness, confusion and nausea.
In very high concentrations, it can cause death.
Buy and Install CO Detectors and
Alarms
The American Red Cross recommends that everyone
install CO detectors/alarms in home and in recreational vehicles.
- Before buying a CO alarm, check to make it is
listed with Underwriter's Laboratories (UL), standard 2034, or there is
information on the package or owner's manual that says that the detector/alarm
meets the requirements of the IAS 6-96 standard.
- Install a CO alarm in the hallway near every
separate sleeping area of the home. Make sure the detector/alarm cannot be
covered by furniture or draperies. Follow manufacturer's instructions regarding
the specific location where to install it. Avoid corner (where air does not
circulate).
- CO detectors/alarms are available for boats and
recreational vehicles and should be used. The Recreational Vehicle Industry
Association requires CO detectors/alarms to be installed in motor homes and in
tow-able recreational vehicles that have a generator or are prepped for a
generator.
What can you do to prevent CO
poisoning?
- Make sure appliances are installed according to
manufacturer's instructions and local building codes. Most appliances should be
installed by a professional. A carbon monoxide detector/alarm can provide added
protection, but is no substitute for proper use and upkeep of appliances that
can produce CO.
- Have the heating system (including chimneys and
vents) inspected and serviced annually. The inspector should also check
chimneys and flues for blockages, corrosion, partial and complete
disconnections, and loose connections.
- Only burn charcoal outdoors, never inside a home,
garage, vehicle or tent.
- Do not use portable fuel-burning camping equipment
inside a home, garage, vehicle or tent.
- Always make sure to turn off any gas-powered
engine (car, truck, motorcycle, ATV, lawn mower, chain saw, or generator) inside
an attached garage or basement. Even if the garage door is open, you can still
be affected or killed by CO. If you must test the engine, take if outdoors
before starting it.
- Always refer to the owner's manual when performing
minor adjustments or servicing fuel-burning appliances, and get help from a
professional if you are unsure how to service such equipment.
- Do not use gas appliances such as ranges, ovens,
or clothes dryers for heating your home.
- If you use a fuel-burning appliance for approved
indoor uses (such as a heater), make sure it is vented to the outdoors following
manufacturer's instructions. Do not use an un-vented fuel-burning appliance in
any room with closed doors or windows or in any room where people are
sleeping.
- Install and use and exhaust fan vented to outdoors
over gas stoves.
- Open flues when fireplaces are in use.
- Choose properly sized wood-burning stoves that are
certified to meet EPA emission standards. Make certain that doors on all
wood-burning stoves fit tightly.
- Have a trained professional inspect, clean and
tune-up central heat systems (furnaces, flues, and chimneys) annually. Repair
any leaks promptly.
What should you do if you experience symptoms of
CO poisoning?
If you think you are experiencing any of the
symptoms of CO poisoning, get fresh air immediately. Open windows and doors for
more ventilation, turn off any combustion appliances, and leave your home. Then
call your fire department and report your symptoms. You could lose
consciousness and die if you do nothing. It is also important to contact a
doctor immediately for a proper diagnosis. Tell you doctor that you suspect CO
poisoning is causing your problems. Prompt medical attention is important if
you are experiencing any symptoms of CO poisoning when you are operating
fuel-burning appliances. Before turning your fuel-burning appliances back on,
make sure a qualified serviceperson checks them for malfunction.
What should you do when the CO detector/alarm
sounds?
Treat the alarm signal as a real emergency each
time. If the detector/alarm sounds and you are not experiencing any symptoms
described above, press the reset button. If the detector/alarm continues to
sound, call the fire department. Immediately leave your home until a
professional checks to find the reason why the detector/alarm sounded, and any
problems are fixed.
How to test a CO detector/alarm to make sure it
is working -
Follow the manufacturer's instructions. Using a
test button, some detectors/alarms test whether the circuitry as well as the
sensor which senses CO is working, while the test button on other detectors only
tests whether the circuitry is working. For those units which test the
circuitry only, some manufacturers sell separate test kits to help the consumer
test the CO sensor inside the alarm.
If you have further questions, please contact your
local fire department or your local public health office. |